The Single-Frame front bumper "S4 B8-Look" replaces the original front bumper of your A4 B7 8H Cabrio and gives your car the sportive look of the new Audi RS4 B7 Cabrio.
Virtues of the Hofele-Design front bumper are its design & fit.
The front bumper can be combined with the S4, RS4 silver and RS4 black front grill. This and the use of other OEM components like the "RS4" mesh for the fog lights guarantees an OEM look which is still individual. OEM components like the Parktronic-sensors, the headlight washer system and the fog lights can be taken from the original bumper. The alloy crash bar can be taken as well, this guarantees complete security in case of a crash.
The bumper is made of the high-quality material PKG. The bumper is already primed and comes ready to paint. Please check our certificate of quality for further information.
The bumper is available for cars with or without headlight washers and with or without Parktronic. If you car has no headlight washers, the openings in the bumper have to be sealed with the OEM caps which are also available at Hofele-Design. The RS4 mesh for the fog lights is additionally needed.
From cars with S-Line exterior package or from the S4 the serial sprayer jets cannot be inserted into the new bumper. Therefore you have to buy the sprayer jets from the normal A4 B7 either from Audi (OEM part no. 8E0 955 101 G (left) + 8E0 955 102 G (right)) or buy them directly from Hofele-Design.
Attention: on cars with 6 cylinder Diesel engine the holders of the intercoolers have to be modified, otherwise it is not possible to insert the fog lights into the bumper! Therefore calculate approx. 30 to 60 minutes of additional working time!
The hood / bonnet scoop "Power Dome" is attached onto the hood / bonnet of your Audi A4 B7 8H Cabrio / Convertible and gives the ordinary hood / bonnet a more dynamic look.
The parts is being glued on, the special glue is part of the delivery.
The side skirts replace the original side skirts of your A4 B7 8H Cabrio and give your car the sportive look of the Audi RS4. The side skirts consits of three pieces per side, the side skirts and four side skirt corners for the front and the back. The side skirts are screwed to the car while the corners are permanently glued to the fenders of your car.
The side skirts are made of the high-quality material ABS, the corners are made of PKG.
The rear apron replaces the original rear apron of your A4 B7 8H Cabrio and gives your car the sportive look of the Audi RS4. The rear apron is permanently glued to the upper part of your rear bumper.
The rear apron can be combined with the "EVO" tailpipes, the tailpipes"Elegance" or the Duplex sports mufflers
The part is made of the high-quality material PKG, the mesh insert is made of paintable alloy mesh.
The tailpipes "EVO"
replace the serial tailpipes of your Audi A4 B7 Cabrio.
To mount the tailpipes on the Cabrio the serial tailpipes have to be cut off and then the new tailpipes get welded on.
"EVO" tailpipes oval, diameter 157x92mm, stainless steel.
Duplex-Sports muffler
replaces the serial muffler of your Audi A4 B7 Cabrio and gives the car a more sportive sound.
The two "EVO" tailpipes are oval, the diameter of the tailpipes is 157x92mm. The tailpipes are crooked on the outside, the edges are raised.
The complete muffler and tailpipes are made of stainless steel.
|
